Accessories

Clamp on D-Ring

(1965-240)

This D-Ring attaches to our standard post at the 22" level.  It may be used as a tie-off if base plate or embed are installed to support a 5,000 lb. load.

Slide on Toeboard 

(1965-60)
Slides onto a standard post for quick installation and removal of toeboard. Will accommodate 2" x 4", 2" x 6", 2" x 10", and 2" x 12" boards.

(lumber not included) 

Clamp on Wood Rail Bracket/Toeboard

(1965-60C)

Clamps onto a standard post.  Will accommodate 2" x 4", 2" x 6", 2" x 10" and 2" x 12" boards. 

(lumber not included) 

Clamp on Corner Bracket for Wood

(1965-280)

Clamps onto a standard post.  Will accommodate 2" x 4", 2" x 6", 2" x 10" and 2" x 12" boards. 

(lumber not included) 



Clamp on 'T' Bracket for Wood Rails

(1965-305)

Clamps onto standard post.  Will accommodate 2" x 4", 2" x 6", 2" x 10" and 2" x 12" boards. 

(lumber not included) 

Post Concrete Protective Tube

(1965-100)

Column Anchored Cable Support

(1965-70)

The cable support clip provides an alternative to welding a nut or washer to columns on lower floors. Clips attach to structure using standard Tek #5 screws, concrete fasteners, or by welding in place. Clips allow for quick and easy cable installation and removal, and are designed to accommodate up to 1/2" diameter cable.

(Cable not included) 

Column Anchored Cable Tie-In 

(1965-220)

Designed to be used at a square tube column for angle changes.

(Cable not included) 

Column Anchored Wood Rail Bracket 

(1965-215)

This bracket is designed to attach to a concrete or steel column. Will accomodate 2" x 4" and 2" x 6" boards.

(lumber not included) 

Diagonal Cable Clamp

(1965-300)

For use with the 39" Erecting Post, or Beam Clamp (if no column is available for support).

(Cable not included) 



Clamp On Cable Guide

(1965-540)

This was designed for additional cables to be used.  Can be attached at (0) zero cable height for debris nets.